
CHAMALEONCode 00355
Chamaleon 552 Quick Fill Body Filler, 1 L
/ pc · incl. VAT

CHAMALEONCode 00355
Chamaleon 552 Quick Fill Body Filler, 1 L
- Manufacturer
- CHAMALEON
- Code
- 00355
- Category
- Fillers
- Country of origin
- Germany
Availability: In stock
38.50 ₾
/ pc · incl. VAT
Quantity
Tbilisi next day · free delivery over 100 ₾
Specifications
General
- Manufacturer
- CHAMALEON
- Code
- 00355
- Category
- Fillers
Origin
- Country of origin
- Germany
Unit and packaging
- Unit
- pc
Description
Chamaleon 552 Quick fill - a two-component, lightweight, fine polyester body filler, 1000 ml, for closing small pores and levelling minor irregularities. It changes colour from green to beige while curing, giving a visual check of the drying process. Sandable after only 15-20 minutes at 20°C. Gives a smooth, glossy, closed surface with excellent standability. Applies directly to iron, steel, galvanised steel, aluminium and its alloys, and GRP.
Mixing: hardener Hardener P, ratio 100:2 by weight. Do not use more than 3% hardener - under- or overdosing can cause spotting in the topcoat. Pot life at 20°C: 3-4 minutes. Do not return mixed material to the can.
Preparation and use: the substrate must be clean, dry and grease-free; sand thoroughly, remove old and loose paint and primers, and degrease before every step. De-rust damaged spots to bare metal and dry-sand with P80/150. On non-ferrous metals (aluminium, galvanised surfaces) a coat of Chamaleon epoxy primer is advised before filling. Once cured, dry-sand only, with P120/240. Do not apply over thermoplastic or acid (wash primer) products. Isolate with a Chamaleon 1K or 2K primer before topcoating. Clean tools immediately after use, with nitro thinner if needed.
Per the manufacturer's data sheet: sandable after 15-20 minutes at 20°C, 5-10 minutes at 60°C. Work at no less than +12°C (polyester filler does not cure below +10°C) and no more than 80% relative humidity, with good ventilation. VOC max. 15 g/l. Shelf life 12 months in the tightly closed original container. See the SDS for safety information.
Application
The product is intended for the following surfaces and jobs:
- Automotive
Not sure whether it suits your job? Call us +995 32 25 600 25 or ask the site assistant in the bottom right corner.


