
CHAMALEONCode G108400274
Chamaleon Polyurethane Body Sealant, 310 ml
· white/ pc · incl. VAT
whiteCHAMALEONCode G108400274
Chamaleon Polyurethane Body Sealant, 310 ml · white
- Manufacturer
- CHAMALEON
- Code
- 00274
- Category
- Sealants & adhesives
- Country of origin
- Germany
Choose a colour
Availability: In stock
19.85 ₾
/ pc · incl. VAT
Quantity
Tbilisi next day · free delivery over 100 ₾
Specifications
General
- Manufacturer
- CHAMALEON
- Code
- 00274
- Category
- Sealants & adhesives
Origin
- Country of origin
- Germany
Unit and packaging
- Unit
- pc
Description
Chamaleon Polyurethane Car Body Sealant 310 ml is a one-component, moisture-curing sealant that forms a flexible, tough joint. It is used to fill and seal welded seams on car bodies, to attach lightweight parts such as cover plates, gaskets, trims and reflectors, and to reduce vibration and noise in body repair. It adheres well even to untreated surfaces: galvanised steel, aluminium, most plastics, glass, wood, concrete, brick and ceramics. Not for bituminous substrates, natural rubber or EPDM. It stays permanently elastic, does not crack, cures without bubbles and can be painted over with all lacquer systems. Available in white, grey, black and beige.
Preparation and use: the surface must be solid, clean, dry and free of dust, oil and grease. Sand metal if needed and let the surface dry fully after degreasing, as moisture causes bubbling. Apply a primer where necessary. Apply with a manual or pneumatic gun, smooth the joint with soapy water and avoid trapping air. Joint width 5-12 mm. Use opened cartridges within 24 hours; in cold weather keep cartridges at about 20°C before use.
Per the manufacturer's data sheet: tack-free in 50-70 minutes, cure rate 3 mm / 24 h (25°C, 50% RH). Density 1.08 g/cm³, Shore A hardness 50±5, elongation at break over 300%, tensile strength over 2.5 N/mm². Work at +5 to +35°C and no more than 80% relative humidity; service temperature -30 to +80°C. One 310 ml cartridge gives 2.6 m of joint at 15 mm width, 1.55 m at 20 mm and 1 m at 25 mm. It can be painted once a skin has formed; if the paint needs oven drying, let the sealant cure fully first. 2K acrylic and water-based paints are usually compatible; test solvent-based paints first. Apply an additional 2K primer over the sealant before a solvent-based underbody coating. Clean tools with alcohol or acetone before the sealant cures. White and grey may change colour slightly under UV light. VOC below 50 g/l. Shelf life 15 months unopened at +5 to +25°C, protected from sunlight, frost and moisture. See the SDS for safety information.
Application
The product is intended for the following surfaces and jobs:
- Automotive
Not sure whether it suits your job? Call us +995 32 25 600 25 or ask the site assistant in the bottom right corner.


